Thread: C5 gto
View Single Post
Old 08-04-2017, 07:10 PM
heinke's Avatar
heinke heinke is offline
MetalShaper of the Month Jan 2018
Join Date: Nov 2009
Location: Livermore, CA
Posts: 381

Originally Posted by blue62 View Post
Great details on your process.
Did you find any change in crown after you turned the edge?
Dave: good question. I didn't experience any change in the crown from turning the flange on the edge. There was however some change in arrangement until I used the shrinker on the flange to put the arrangement back. This was expected and what happens when a flanging a curved piece.
Joel Heinke
Be original; don't be afraid of being bold!
Reply With Quote