[dbuch]

I know this is an old thread. I too purchased these dvds - the complete set - and they are filled with a wealth of information on making and using and tuning pullmax dies. My question is: does anyone here know what ever happened to Terry Stolarski? I used to deal with his son Mike back when they had their website going, and I would from time to time buy doming dies from him. They were top quality with beautiful welds.


I have often talked with fellow metal shapers and discussed Terry's videos and recommended them - but they apparently haven't been available for at least 5 years or so now, and the website has disappeared. He also used to sell his videos and some tooling on Ebay - but again he hasn't been on there for many years.


I will appreciate any information you can provide.


Thanks,
David