View Single Post
  #2  
Old 03-30-2022, 08:07 AM
Don Papenburg Don Papenburg is offline
Member
 
Join Date: Dec 2018
Location: LaSalle county Illinois , USA
Posts: 99
Default

If you can weld SS you can make the tanks you need . Form the box ,2- 90s or four 90s and weld the seams . make a baffle by cutting 45s on each corner weld it in place , with 20 ga. I would make it a bit over size and bend 90s to make it fit snug then weld on the flange edge . Make your end plates oversized , 90s all around for a snug fit with the flange out weld the edges . check for leeks . Another thing cut holes for fill and draw before bending , I think it is a lot easier then after the tank is welded up. Make a small tank for practice it will help with the big tanks.
Don
__________________
Don Papenburg
Reply With Quote