View Single Post
  #6  
Old 06-04-2022, 01:00 PM
Mr fixit Mr fixit is offline
Member
 
Join Date: Aug 2014
Location: Portland, Oregon
Posts: 226
Default

Hi Guys,

I new you would come through for me. What a simple suggestion of the flaring tool. Didn't even consider it but I have it sitting right here on the bench because I just finished a complete brake system rebuild, so I'm ready to go.

Marc, I do have a metal lathe and could do as you suggested, but sincec the flaring tool is out and I only have to make 10 of them It's going to be just as easy with the tools already on hand, but it's a great suggestion that I will keep in mind for the future.

Mark I did just that, I went to the hobby store and got the 1/4" tube there. I didn't check the wall thickness but that sounds about right.

Again all I can sasy is you guys and this site are the best...!!

TX
Mr fixit
Chris
Reply With Quote