View Single Post
  #5  
Old 12-14-2020, 05:50 PM
Hotflint Hotflint is offline
Member
 
Join Date: Dec 2019
Location: Calgary, Alberta, Canada
Posts: 27
Default

I should have shown it in the video, but I did 2 things. I drilled a spot on the lifter shaft for the setscrew to go into tighter. This was hard to keep it aligned when I did this, but it worked. Not sure if all of these cheap ones are like this, but it was still a little sloppy, I welded a piece of half inch plate to the side that I had drilled and installed a bronze self lubricating bushing and welded a rod down from the bottom anvil holder. This made it really rigid and still smoothly goes up and down
__________________
Dave
Reply With Quote