So, before removing the paint on the right rear quarter panel, I was'nt sure how to deal with it while repairing the hellhole. I knew cutting it would allow me a better access but cutting good metal is always a hard decision..
Well, from that point of view I got "lucky"
because there is no good metal
Here without paint:
And I have a habit that I built(or make sure I have it) the part before cutting, to ensure I won't miss any measurement/positioning. So here we go !
Making my template :
And starting :
And after a couple hours:
I left the front part undone to be able to make a good door gap when it comes to that time.
So, now that this is done..cutting!
Stay tuned, the work on the hellhole is going to start!
Cheers
Antoine