View Single Post
  #1  
Old 12-18-2020, 10:14 AM
idickers's Avatar
idickers idickers is offline
Member
 
Join Date: Sep 2009
Location: Rochester, NY
Posts: 190
Default Brazing/soldering question

I apologize if this is not exactly a sheet metal question, but I didn't know where to post. I need to make a repair on a cast iron engine block on a running engine, and am looking for ways to repair without stripping the block down for welding. I started out trying to remove an easy-out that had been broken while attempting to remove a broken bolt. This is in the flange of the block that mounts to the transmission bell housing.

All foreign pieces are now removed, but in the process I removed too much material and have to fill a void that I would like to next drill and tap for a new bolt. Is there a way to use oxygen-acetylene to braze or solder in filler for this type of application? Or to backstop a time-cert?
__________________
Ian in Rochester, NY
M2 site
Reply With Quote