Thread
:
My first complete car body.
View Single Post
#
114
11-08-2022, 04:58 AM
Jaroslav
MetalShaper of the Month April 2020, September 2021, November 2022
Join Date: Dec 2012
Location: Czech Republic
Posts: 2,601
I'm finally go on with the car. Forming the sheet exactly to the shape of the skeleton was an experience. Always a little bit more and then a little bit more. 100x in hand, 100x to compare and think about the overall shape. When you shape in one place, the other side moves elsewhere.
Settlement on the car. The biggest problem I am solving now is drawing a line according to which I will bend the edge for the wire.!!! How to draw a smooth line. In the right place. After bending the edge, everything changes again. I have to balance the shape and in the meantime I will think about how to draw the line. Measurement is a tough nut to crack...
__________________
Jaroslav
Jaroslav
View Public Profile
Send a private message to Jaroslav
Find all posts by Jaroslav