Here ya go, Terry.
This is small part of my shop. I had a few of my bikes in for service and detail a few years ago.
I cannot post any current pics of my shop due to a few confidentiality contracts I'm tied to for a few concepts that I'm building. However, if you follow this link it will take you to a Ransom Motorcycles facebook album to see some older pics.
as for shops, I have about 4700 sq.ft. with a lot of room to expand. Tooling is really simplistic consisting of a Bridgeport, planishing hammer, built E-wheel, some heavy steel custom built benches, a couple bike lifts, custom built frame Jig and swingarm jig, torches, and misc. hammers and hand tools. I have a Pullmax on its way from Clay Cook (hopefully it'll be here this week). I make a lot of my own tooling specific to my techniques. I'd like to bring in a Yoder but seem to have some difficulty locating one. (maybe I'm looking in the wrong places). I dont want a knock-off.. It's gotta say Yoder on it.. I'm a bit nostalgic when it comes to sheet metal craft..
Start on the side and gradually press into full time. I believe if you can dream it, you can achieve it.
facebook album:
https://www.facebook.com/media/set/?...6549087&type=3