Ben, what is the length and height of the panels on your '63?
This could also be done in a bead roller with a urethane lower doing one or 2 flutes per pass. There is a joggle top and bottom about 1/2" high with a flange about an inch or 2 wide to slip under the adjacent sheet metal. I believe the gauge is about 22 or 20. At each end of the trim there is an area that is at right angles to the fluted area. I think the originals were pressed in a die. I would probably weld those pieces in. Most of the panels on my '48 are in good shape. I might replace one short section. How soon will you need these?
|