All MetalShaping

All MetalShaping (https://allmetalshaping.com/index.php)
-   Introductions (https://allmetalshaping.com/forumdisplay.php?f=7)
-   -   Willys Aero Project (https://allmetalshaping.com/showthread.php?t=5845)

vettelang 04-01-2012 12:27 PM

Willys Aero Project
 
As an introduction I am working on a 1954 Willys Aero Eagle Custom, which has many reverse curves in its front and rear shape. I have the uniframe rails reinforced and have just started on patches for the rear end. I did make a complete rear valance panel that actually came out OK.

Located in Motown.

troppo 04-01-2012 03:09 PM

Welcome to the madhouse mate
theres plenty of knowledge to be picked up on these boards and you may even be able to teach some of us a few things

A wise man (not me for sure) once said there are main points to life
1/ The only stupid question is the one not asked
2/The day you stop learning is the day they put into the ground


Cheers mate
Troppo

Peter Tommasini 04-01-2012 05:18 PM

HI Lang welcome to the forum
Peter

HEATNBEAT 04-01-2012 07:00 PM

Hi and welcome Les!:)


All times are GMT -5. The time now is 04:58 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.