Sheet Metal Virgin
 

Well, I'm not a total virgin to working with sheet metal, but almost all of my experience has been with tubing, angle, plate, etc. I have done some very simple things with sheet metal, but I am looking to move beyond the "rolling over" stage to the "crawling stage". :D From what I've read so far, there is a lot of information here which should really help me out. I need to read a lot before I can ask any questions, but this sure looks like the place to be.

Marty

Hi, and welcome Marty!:)

Marty, welcome and thanks for the introduction. Lots of information on the site the help you improve you skill and learn new methods. Thanks for joining us.

Welcome to the site Marty
Peter

Hello Marty, welcome to allmetalshaping.

David