new to the forum
 

hi everyone, thought id introduce myself to you all. i work as a engineer in yorkshire, uk, and i have just bought a small sliproll to make an exhaust system for my bike in my spare time. after having a play around with them i have realised they are a bit more difficult to use than they look, and would like to learn to use them properly

Rob, welcome and thanks for the introduction.

Welcome to Allmetalshaping Rob!

Hi Rob, Welcome to the site, I am also from the UK. There is a book with some good stuf about shaping cones etc. and using the slip rolls. I will try and fiind the title later at work and post it on here for you.

David