Greetings from Pittsburgh
Hey everyone,
My name is Bob, and I operate a small fabrication outfit as a side-hustle. I've been into cars for as long as I can remember, and got into fabrication after I first saw a twin-turbo Nelson small block. Purchased a TIG welder at 18, and have been adding to the tool pile ever since. Being several project cars in at this point, I'm looking to get more into fine metal shaping. For simply better bodywork on rebuilds, and open some doors on custom stuff. Currently have a shot bag, Harbor Freight planishing hammer (in need of some upgrades, but too cheap to pass up, at the time), and just picked up a set of Martin hammers and dollies. I have a fair bit of other fabrication tools, and looking to squeeze an English wheel into the mix, in the near future. Always looking to learn new and old tricks, to be more efficient and produce higher-end results. Look forward to diving in... |
All times are GMT -5. The time now is 07:32 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.