Introduction from NE
 

I started a 1917 Chalmers speedster project with virtually all parts except the cowl on back. After finding the correct fenders, I decided that I couldn't have a fiberglass body with steel fenders. I am in over my head, but I hope to get ideas on building the body as I read and search the posts.

Dale

You're not alone in NE
 

My shop is in omaha. I don't have all the answers but am more than willing to assist you.

Welcome to the forum, Dale. If you're in over your head, it sounds like you'll fit right in. There's lots of good people & experience here to help.

Hi Dale welcome to the forum
Peter

Also in Nebraska
 

You would benefit from metal shaping classes given at Custom Rides in Hastings NE by PatMan (on this site). Pat's shop number is 402-462-8581. His classes are all hands on with a maximum of 4 people. I have enjoyed my experience with his classes.

Hello from Hastings!! Good to see another Nebraska guy! Welcome to the forum lots of good information and good people here. My door is always open so if you get stuck give me a shout!

Pat