All MetalShaping - New from Anderson SC

New guy here, have been doing restoration work for the last ~10 years. The last few, and especially my current project in the shop have pushed me to develop my metal shaping skills further to be able to make the needed repairs properly. MP&C has been posting the progress of the '55 Wagon on another forum I'm on, and he mentioned this forum so I wanted to sign up and check it out.

I'm currently in the middle of scratch-making the bottom 1/4th of a '40 Packard 120 Convertible Coupe. No replacement panels are available so it's all hand made. Most of the panels were very rotted, making it difficult to make accurate patterns.

Full build details are posted on the 67-72chevytrucks forum, link is below.

http://67-72chevytrucks.com/vboard/s...d.php?t=639218

As delivered:

http://i1315.photobucket.com/albums/...80703106_n.jpg

http://i1315.photobucket.com/albums/...62646982_n.jpg

Digging deeper:

http://i1315.photobucket.com/albums/...59586264_n.jpg

http://i1315.photobucket.com/albums/...59361847_n.jpg

Body squared up, braced, new pans fabricated.

http://i1315.photobucket.com/albums/...81802157_n.jpg

Body stripped and shot with epoxy.
http://i1315.photobucket.com/albums/...psjmfkshzn.jpg

New parts ready to go back in.

http://i1315.photobucket.com/albums/...psyoujcgyw.jpg

One side completed. I'm currently finishing up the passenger side. Once the cab section is done I'll start on the trunk floor and rear inner fendewells.

http://i557.photobucket.com/albums/s...FEA5C66692.jpg