All MetalShaping

All MetalShaping (https://allmetalshaping.com/index.php)
-   Introductions (https://allmetalshaping.com/forumdisplay.php?f=7)
-   -   Hi from WA (https://allmetalshaping.com/showthread.php?t=11505)

tonyh58 05-06-2014 07:24 AM

Hi from WA
 
a bit about myself. the WA is Western Australia (Perth) which is swiftly being dug up and sent to china. I have two cars on the go at the moment, a 71 Valiant Coupe similar to the dodge dart of the same era. this was going to be a quick tidy up and then drive(haha), but I keep going "while the weheels are off I will just do this and then that", so taking time. the other is a 48 Plymouth 4 door which is getting a Jag front and rear and a 360 v8. this will be a long term project!

lots of body work to be done and this is the reason I have joined the site.

presently house sitting and the cars are at my house so I don't get there much so slow going at the moment.:(

Tony

HEATNBEAT 05-06-2014 09:13 AM

Hi Tony and welcome!:)

Jere 05-06-2014 10:08 AM

Hello Tony and welcome to the site.

Jere

Peter Tommasini 05-06-2014 02:36 PM

Hi Tony welcome to the forum
Peter

the hammerworks 05-06-2014 06:19 PM

hello tony ,welcome to the site

Charlie chop 05-10-2014 07:26 AM

Hey mate, welcome, I'm in pinjarra and have a 69 val hardtop project.

David Gardiner 05-10-2014 09:58 AM

Welcome to the forum Tony.

David


All times are GMT -5. The time now is 07:43 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.