All MetalShaping

All MetalShaping (https://www.allmetalshaping.com/index.php)
-   Introductions (https://www.allmetalshaping.com/forumdisplay.php?f=7)
-   -   Introduction (https://www.allmetalshaping.com/showthread.php?t=20237)

Doc Cox 01-12-2021 06:42 AM

Introduction
 
Good morning, just a few lines about me, Iam a 65 year old guy living in Royal Wootton Bassett England, have had an interest in all things engineering etc. was a vehicle mechanic it the Royal Air Force for twenty years, retired and worked for myself for seven years, my hobby has always been engineering and have built up my garage to revolve around this, four years ago we had a fire in the garage that destyoyed everything...two motorcycles, lathe, milling machine and other smaller items, luckily noone was hurt and it was all insured new for old so now have a very well setup workshop after the rebuild, ironically the fire did me a favour, currently rebuilding my 1982 Virago that was caught in the fire and have reprofiled the tank plus made a sheet metal tail end for the seat, all a new learning curve for me, regards to all and Happy New Year, Doc Cox.

metaldahlberg88 01-12-2021 10:50 AM

Welcome to the community, Doc Cox

cliffrod 01-13-2021 09:51 PM

Welcome to the forum, Doc.


All times are GMT -5. The time now is 02:56 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2021, vBulletin Solutions Inc.