Rumley tractor
Just a couple pics of the radiator I’m building for a 1918 Rumley Do All tractor.got to use my Trumpf I just picked up to offset the tank edges.Not the most perfect edge but not bad for my first go at it,besides the customer wants the rad to look a 100 years old so I get to build my first relic.
http://www.allmetalshaping.com/pictu...ictureid=20272 http://www.allmetalshaping.com/pictu...ictureid=20273 [IMG]http://www.allmetalshaping.com/picture.php?albumid=1 |
Nice , what did you use to shrink the edges ?
|
I have a set of Shrinker and stretcher machines.They are the hand ones that I just put an air cylinder kit from Mittler brothers on.
|
Looks good so far. Maybe go for a faster stroke speed to lose that crinkly edge and spray some thin oil on to let the part pass through easier. Please don’t take that as criticism but something that might help next time.
|
Yeah,the second side panel I did raise the speed a little.It came out better.I’m learning as I go any points are welcome.
|
All times are GMT -5. The time now is 03:01 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.