#1
|
|||
|
|||
Trick for accurate conical 2d bends?
I am making ducting for the engine cooling plenum on a homebuilt airplane. Material is 0.032 2024t3, which is quite stiff. I need to make 2d bends i.e. No shrinking or stretching to go from a square section to a radiused section. I ave been doing it by many small bends in a finger brake. It works but it is a bit hit and miss and leaves a faceted surface. Are there any other good tricks out there for doing this?
IMG_1882.jpg
__________________
Scott in Montreal |
Thread Tools | Search this Thread |
Display Modes | |
|
|