#1
|
|||
|
|||
Introduction from NE
I started a 1917 Chalmers speedster project with virtually all parts except the cowl on back. After finding the correct fenders, I decided that I couldn't have a fiberglass body with steel fenders. I am in over my head, but I hope to get ideas on building the body as I read and search the posts.
Dale |
#2
|
|||
|
|||
You're not alone in NE
My shop is in omaha. I don't have all the answers but am more than willing to assist you.
__________________
Hans iwand |
#3
|
|||
|
|||
Welcome to the forum, Dale. If you're in over your head, it sounds like you'll fit right in. There's lots of good people & experience here to help.
__________________
AC Button II http://CarolinaSculptureStudio.com https://www.youtube.com/channel/UCzSYaYdis55gE-vqifzjA6A Carolina Sculpture Studio Channel |
#4
|
|||
|
|||
Hi Dale welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM |
#5
|
|||
|
|||
Also in Nebraska
You would benefit from metal shaping classes given at Custom Rides in Hastings NE by PatMan (on this site). Pat's shop number is 402-462-8581. His classes are all hands on with a maximum of 4 people. I have enjoyed my experience with his classes.
__________________
Alan |
#6
|
||||
|
||||
Hello from Hastings!! Good to see another Nebraska guy! Welcome to the forum lots of good information and good people here. My door is always open so if you get stuck give me a shout!
Pat |
Thread Tools | Search this Thread |
Display Modes | |
|
|