#1
|
|||
|
|||
Stamping baby!
So I've been pretty busy lately.
For a while I've been working on ways to reproduce parts of a 1977 Torana Hatchback, so far I have come up with these stamping dies I made on my old Milling machine. Basically 90% is stamped then the edges are cleaned up with hammer and dolly. So far I have done a few tests, full length trunk sill and 3/4 lengths. This will end up being just one stamping process of about 3 or 4 stages. Eventually the idea is to stamp out an entire rear panel like in this hand made prototype. 20171109_155225[2].jpg 20171110_191653.jpg 20171110_191500.jpg 20171110_160638.jpg 20171110_191510.jpg
__________________
Bart Risuccia Last edited by Bart; 11-10-2017 at 06:43 AM. |
Thread Tools | Search this Thread |
Display Modes | |
|
|