|
#1
|
|||
|
|||
Atomic hydrogen arc welding
I picked up a Miller atomic hydrogen arc welder. There appears to be multiple ways to set up the torch. It also looks like I can convert my flame spray torch to work with it. Anyone have any experience using one?
__________________
Bill Funk |
#2
|
|||
|
|||
Quote:
Set your carbons to a gap of 1/8" to start. Open the fuel gas, ignite the arc, grab your filler and you are off to the races.
__________________
Kent http://www.tinmantech.com "All it takes is a little practical experience to blow the he!! out of a perfectly good theory." --- Lloyd Rosenquist, charter member AWS, 1919. |
#3
|
|||
|
|||
Atomic Welder
Somebody at Miller must have been out to lunch when they came up with this name. I 'd be scared of radioactivity.
__________________
joe mato |
#4
|
|||
|
|||
Atomic Welder
Somebody at Miller must have been out to lunch when they came up with this name. I would be scared of radioactivity.
__________________
joe mato |
#5
|
|||
|
|||
Quote:
... and was developed before big nuke science - but after Curies and the pitchblende derivatives.
__________________
Kent http://www.tinmantech.com "All it takes is a little practical experience to blow the he!! out of a perfectly good theory." --- Lloyd Rosenquist, charter member AWS, 1919. |
#6
|
|||
|
|||
atomic hydrogen arc welding
Kent,
Thanks for the tips. I will be picking up the hydrogen cylinder next time I get a tank refilled. I will let you know how it goes. The whole world will hear about it if I don't heed your advice on leakage. Sounds like you have used one before? I see on your profile that you used to work for Harrahs. Did you do any work on their Mercer? Bill
__________________
Bill Funk |
#7
|
|||
|
|||
Quote:
PS: I've had my hands on one and I've seen the ALCOA film on the setup and operation of the 1940 machine. I can send you a dvd of it, if needed. Might be a tad different from your Miller model.
__________________
Kent http://www.tinmantech.com "All it takes is a little practical experience to blow the he!! out of a perfectly good theory." --- Lloyd Rosenquist, charter member AWS, 1919. Last edited by crystallographic; 09-01-2015 at 02:01 PM. |
#8
|
|||
|
|||
I have no experience using one but am pretty sure it was covered in the Audels Welders guide I have at the house. I'll try to remember to check it out when I get home in the morning and see if there's anything relevant.
These books are usually around $5 each at used book stores when you find them.
__________________
Jamie, the kid who took his toys apart... |
Thread Tools | Search this Thread |
Display Modes | |
|
|