#1
|
|||
|
|||
Wire edge straightening question
Hi Group,
I have door sill trim pieces that are U shaped with a 2"side x 1" top x 1.5" side x 34" Long and has a wire edge on the 1.5" side. I am straightening the original pieces as they were pried off by a previous owner which bent both sides. I have got the 2" side done but I seem to be chasing the wire side and can't seem to keep it straight. I have been using a .75" of flat steel as my dolly, should I be using something else for better results? advise would be appreciated. TX |
Thread Tools | Search this Thread |
Display Modes | |
|
|