|
|
|
#1
11-23-2010, 10:02 PM
|
||||
|
||||
introductions
hi ,my name is bill
been lurking for quite a while. this computer stuff is fairly new to me  i think i have to move computer to shop.seem to be spending to much time lurking[i rather call it learning]the talent here is kinda humbling ,ihope to partcipate more. thnks for the kick in the butt. p.s. what is a signature? 
|
|
#2
11-23-2010, 10:22 PM
|
||||
|
||||
|
Bill, welcome and thanks for the introduction. The signature is your name that is automatically put at the bottom of each post you make. If you click on User CP, upper left side of the tool bar a drop down menu will appear. This is where you can enter you signature among other thing.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#3
11-24-2010, 03:37 PM
|
||||
|
||||
|
Hi Bill.
Welcome to allmetalshaping, the phase under the site name says it all, not sure of something just ask, guys here love sharing their knowledge. Enjoy browsing, post when you can. By the way anything below the solid line is signature.
__________________
Tom Poulter Follow the Dream - Sideways -  - But don't fall-off the edge'good to know you guys care' https://ctrestorations.com/ Last edited by Z5Roadster; 11-24-2010 at 03:40 PM.
|
|
#4
11-24-2010, 04:04 PM
|
|||
|
|||
|
Hello Bill, welcome. I don't think we are too intimidating! We all had to learn at some point.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
 |
|
|
Linear Mode
