#1
|
|||
|
|||
New guy from Bloomington, Indiana
Hello all... I am Jim and I'm looking to learn how to do metal flares on my LS1 Rx-7 so I can put larger rear tires on it.
I'm basically starting from scratch so I have ALOT of reading to do.. thanks -Jim
__________________
Jim I'd like to find your inner child and kick it's little ass -Eagles |
#2
|
|||
|
|||
small world i'm Bloomington also. good place to learn
__________________
Mark |
#3
|
||||
|
||||
Hello Jim and welcome to the forum.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer. Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver. |
#4
|
|||
|
|||
Hi Jim welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM |
#5
|
|||
|
|||
Quote:
I joined to get some idea how to manipulate metal since I have an old Jeep Cherokee that needs some metal replacement and after buying David Gardiner's metal shaping by hand, gave me more confidence to start practicing and since I don't have the big tools, I am limited to hand tools. Link to David's thread and his DVD. http://www.allmetalshaping.com/showthread.php?t=172
__________________
Bob Last edited by Hoosier8; 11-14-2015 at 10:01 PM. |
|
|