#1
|
|||
|
|||
Need some help on my first body work job
Gday metal shapers im after some help. Im attempting my first body work job on my 69 Dodge coronet. The front left fender has copped a good hit at some point in its life and was covered quite deeply in bog. Ive attached a picture(hopefully). It had a deep crease in it which i have managed to get most of it out but now there is still a low spot across the panel which im having dramas getting out. It appears to me that from above the body line(red line) has a low up to the blue line. im just trying to figure out what is the best way to go about fixing this.
20180807_162357.jpg Thanks
__________________
Glenn Walk |
#2
|
|||
|
|||
Glen
MAKE SURE that the line is right first ,then flipper the low up. If too high simply shrink the spot with oxy but make your shrinks very very small! Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM |
#3
|
|||
|
|||
Quote:
BTW I emailed you about your DVDs the other day and will be sending the money through this week.
__________________
Glenn Walk |
Thread Tools | Search this Thread |
Display Modes | |
|
|