#1
|
|||
|
|||
skateboard wheel for bead roller?
I've been seeing alot of people using skateboard wheels on their bead rollers to perform different task. Does anyone have a particular type or a source for these wheels? I'm using the harbor freight roller and I think the shaft is 22 mm. Dia. Thanks, Dave
__________________
Dave Tighten it till it loosens, then give it a quarter turn! Last edited by dwhip361; 09-11-2012 at 09:30 AM. |
#2
|
|||
|
|||
I think a 22mm bearing was common when i was searching for them.Check ebay,thats where i bought mine.I think i drilled out the center with a 7/8" bit.
__________________
Jim Bob |
#3
|
||||
|
||||
Here are a couple of my threads, the first on modifying the skateboard wheels:
http://www.allmetalshaping.com/showthread.php?t=5846 The second with it being put to use... http://www.allmetalshaping.com/showthread.php?t=5974
__________________
Robert Instagram @ mccartney_paint_and_custom McCartney Paint and Custom YouTube channel |
#4
|
||||
|
||||
HF
I got a tipping die and soft die from Hoosier .I also got tank roll dies,works as good.
__________________
Sean McMahon |
Thread Tools | Search this Thread |
Display Modes | |
|
|