|
|
|
#1
10-04-2011, 12:55 PM
|
||||
|
||||
Introduction
Hello everyone, My name is Ken Loomis and I'm excited to have found this group. I'm brand new to shaping sheetmetal but I've always admired it from afar. I've fabricated and built dirt track cars and hot rod resto's but only so much as bolt on/off and chassis mod's/welding. Having been a plumber/contractor for 25+ yrs. I'm trying to make a career change that follows more of my passion for metalwork and car fabrication. I look forward to reading many posts and viewing more of the fantastic work thats being created all across the globe! Very exciting stuff. Feel free to email, call or post replies with any suggestions or advise for budding shaper, thanks.
__________________
Ken Loomis 415-250-4851 kloomis@me.com 
|
|
#2
10-04-2011, 01:31 PM
|
||||
|
||||
|
Ken, welcome and thanks for the introduction. There is a lot of information here to help you learn metal shaping. If you have a question, ask and someone will help you. Hope you are successful with the career change. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#4
10-05-2011, 12:32 AM
|
|||
|
|||
|
Welcome to the Forum Ken
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#5
10-05-2011, 04:18 PM
|
|||
|
|||
|
Welcome to the site Ken.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
 |
|
|
Linear Mode
