#1
|
|||
|
|||
phase converter question
I chose shop safety for this post because I'm not sure where else to post it, and I've been told it's a serious safety issue. And I'm not quite sure this is technically a "metal shaping" question, but it is for my shop, where I hope to do metal shaping someday .
I need someone to educate me on phase converters. I am looking at some different equipment that I can get for a song, but it's all 3phase, and I only have single phase in my shop. I'd like to do it, but it has to be done right, safely, and economically. Thanks in advance. Kev
__________________
Kevin Booth |
#2
|
||||
|
||||
Kev, sent you a PM.
__________________
Joe Hartson There is more than one way to go to town and they are all correct. |
Thread Tools | Search this Thread |
Display Modes | |
|
|