All MetalShaping

Go Back   All MetalShaping > General Metal Shaping Discussion > Basic questions and answers
  Today's Posts Posts for Last 7 Days Posts for Last 14 Days  

Reply
 
Thread Tools Search this Thread Display Modes
  #31  
Old 06-09-2021, 10:47 AM
beauddan beauddan is offline
Member
 
Join Date: Feb 2017
Location: Quebec, Canada
Posts: 8
Default

you have already stretched the high crown section which you marked with the red lines quite a bit, you have rolled that part but stopped 2 inches from the end of the panel, which holds the sides upward and keeps them from going down. If you notice, the panel is out of shape, too much shape in the middle. Do as GoJeep mentions, start by stretching only these two parts at the end of the fender, but stay away from the red lines. Then you reassess the situation.

You're almost there.
__________________
Daniel
Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump

All times are GMT -5. The time now is 04:00 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.