|
|
|
#1
04-23-2016, 05:02 PM
|
|||
|
|||
Need to know more.
Hi
I'm Don Boatman. I spent the last 50 years working in Power Plants and High Voltage substations. Now I am restoring a 1963 Porsche, metal work, mechanical and paint. I've got most of the rusty inner body parts cut out and replaced with parts I could make. Now I need to weld on a new front piece and make part of a fender (an almost flat piece) with a wire edge crimped on the inside. This looks like a good website with the information and help I will need. Thanks Don
__________________
Don Boatman 
|
|
#2
04-23-2016, 08:56 PM
|
|||
|
|||
|
Hi Don welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#3
04-24-2016, 01:06 PM
|
||||
|
||||
|
Hello Don and welcome to the site from another Californian.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
