|
#1
|
|||
|
|||
Power hammer die questions
Does anyone know what angle the dovetail is for yoder style hammer dies, also on the die holder upper and lower, is there a taper in the opening? I'm Thinking it is 1 1/2 degrees on one side and straight on the other, also I was wondering how deep the dovetail slot is. Thanks guys
__________________
Charles c. Guffey |
#2
|
|||
|
|||
An old thread, I know, but it would be nice to see the answer. I'm wondering if the retaining keys are tapered over the length only or length and width. Anyone got some dovetail and key dimensions they'd like to share?
__________________
Gareth Davies |
#3
|
|||
|
|||
I would ask Fay Butler. He makes dies for sale and he wrote a book on the Yoder. faybutler.com
If anyone would know it would be him. I have read that changing the dies in the dovetail mount while maintaining alignment with that wedge thing is difficult
__________________
Scott in Montreal Last edited by sblack; 01-18-2017 at 03:18 PM. |
#4
|
|||
|
|||
im pretty sure he said 1 degree taper for the lock pin. as far as the angle of the dovetail itself i dont remember. ill check my notes tonight
__________________
Steve |
#5
|
|||
|
|||
They look to be about 10 degree per side on the dovetail but are obviously offset to allow for the width of the key. From what I've read elsewhere, I saw figure of 1/8" per foot taper with the small side being the left of the anvil (die mount) mentioned. I've read dozens of posts today but the only real figures I can find is that the large Yoder dies are 3" square and that's about it. I'm sure a lot of these features can be made to what suits you but it would be nice to find some original dimensions.
__________________
Gareth Davies |
#6
|
|||
|
|||
Quote:
The photo below is Red’s #2 Pettingell mounted to a Yoder cast base. The carful observer will notice the shims spacing the dies together and also the crank pin is nearly centered for a short stroke. My guess is he was probably using it for aluminum or possibly planishing a panel. By the way there is a section for “power hammers” in metal shaping tools where this thred really belongs. Maybe a narrator will move it. ~ John Buchtenkirch Red's #2 Pettingell.jpg
__________________
John |
#7
|
|||
|
|||
Could be worth a look, thanks for the tip.
__________________
Gareth Davies |
Thread Tools | Search this Thread |
Display Modes | |
|
|