|
|
|
#1
12-28-2015, 06:21 PM
|
|||
|
|||
novice to sheet metal - Iowa guy
I've been working on a hot rod project, a 1931 Ford pickup. In my local community I have learned a lot from an experienced fabricator... But realizing tat sheet metal fab is a great big world! Fascinating stuff. you're never too old to learn and have fun.
So I joined this group to learn. I am a "keep your ears open and mouth shut" kinda guy so I won't be an active poster, unless my comments can add value. Thanks, in advance, for letting me join and learn from you all.
__________________
Walt 
|
|
#2
12-28-2015, 07:29 PM
|
|||
|
|||
|
Hi Walt welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#4
12-29-2015, 11:56 AM
|
||||
|
||||
|
Hello Walt and welcome to the forum.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
