#1
|
|||
|
|||
Hello from Russell
Hi All,
A big hello to all members. I have been away from panel beating and (minor) fabrication for the past 20 years. Its time to get back into it and learn from all you talented people. I have just purchased an old 1937 Chevy to restore. There are a lot of panels to replace, make and repair and had been looking around for this exact forum. I hope to gain information and see where this knowledge and skills take me. Regards, Russell
__________________
Russell 37 Chev Last edited by Rusty68; 12-02-2016 at 04:19 PM. |
|
|