#6
|
|||
|
|||
I'm not sure if this is of any interest but when I needed to fabricate a valve cover for a rare 1950s British engine I etched the design onto the ali with Ferric Chloride using a design that was printed onto self-adhesive plastic that is normally used for sign writing on the sides of small Vans and trucks.
If the top face of the covers is thick enough then you'd be able to etch out the design more akin to the original GTO shape. Rob (Beginner)
__________________
Rob Thomas, Cardiff, Wales, UK Last edited by Steve Hamilton; 01-02-2018 at 10:18 AM. |
Thread Tools | Search this Thread |
Display Modes | |
|
|