|
|
|
#1
08-24-2015, 10:22 AM
|
|||
|
|||
New member
Good morning, new to the forum and looking to capitalize on the knowledge and experience of the hundreds before me. I have taken several TIG welding classes yet to continue to struggle with 1/16" al. for the life of me, I can not avoid burn through, butt and or lap, any suggestions would be appreciated.
__________________
Joseph J 
|
|
#2
08-24-2015, 11:35 AM
|
||||
|
||||
|
Hello Joseph and welcome to the forum.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#3
08-24-2015, 05:30 PM
|
||||
|
||||
|
There will be answers on here for sure. Just post the question in the welding sheet metal section so more will see it.
__________________
Marcus aka. Gojeep Victoria, Australia http://willyshotrod.com Invention is a combination of brains and materials. The more brains you use, the less materials you need.
|
 |
|
|
Linear Mode
