|
|
|
#1
08-23-2015, 11:17 PM
|
|||
|
|||
Newbie
Hello everyone. Brand new to metal shaping. I am looking to buy an English wheel. I could buy a new one, but that's too easy and makes far too much sense. I am thinking of a John Heine 1940's era cast iron 42". What do you guys tho k about that? I am fueled by a passion to make a duplicate of a roadster my dad has from the 1950's. Hope you all are well!
Rich 
|
|
#2
08-24-2015, 11:40 AM
|
||||
|
||||
|
Hello Rich and welcome to the site.
You will get lots of help on this site. Be warned we like lots of pictures of your build. Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
