|
|
|
#1
09-23-2015, 05:15 PM
|
|||
|
|||
Fng
I have a 1957 Chevy Cameo that I'm restoring and am interested in learning about the basics of metal shaping.
I am a Navy Pilot and enjoy a hobby of hotrodding and flying GA airplanes in my spare time.
__________________
Kelly Amateur hotrodder 1957 Chevy Cameo Navy pilot 
|
|
#3
09-23-2015, 10:35 PM
|
||||
|
||||
|
Welcome to AllMetalShaping Kelly and thanks for your service. I have huge admiration for anyone who can land an airplane on a carrier. Metalshaping should be a piece of cake by comparison.
__________________
Kerry Pinkerton
|
|
#4
09-24-2015, 12:42 AM
|
|||
|
|||
|
If you're a North Island guy, you should have been here last week. Check out the Fallbrook thread in the events section. For a newb like myself, it was a very eye opening experience and not to be missed. Mike ( and friends ) unlocked many metal mysteries and there were opportunities to network with others, try new tools, ect.
__________________
Bob Innes
|
|
#5
09-24-2015, 04:58 PM
|
||||
|
||||
|
Hello Kelly and welcome to the forum and thank you for your service!
  There is a get together in Santa Cruz at the end of October. Hope you can make it. Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer. Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
