#1
|
||||
|
||||
wire edging dolly
wire edging dolly for putting a 1/8 wire on the edge of sheet metal with built in scribe
wetool 001.jpg scribe the bend line wetool 003.jpg set the dolly on the bend line a.jpg start to bend by hammering about 15 degrees at a time b.jpg c.jpg e.jpg turn the dolly around and hammer on the flat to install wire o.jpg use the roll over dolly to fiinsh setting the edge snug to the wire wetool 010.jpg dolly with the finish wire dolly I sell them for $40 with free shipping in the USA and $16.95 shipping world wide you can pay with paypal to: rscottmfg@sbcglobal.net or send me a check to: Rick Scott 1632 Jefferson Ave. Madera, Ca. 93637
__________________
Rick Scott The second mouse gets the cheese! Last edited by HEATNBEAT; 08-15-2012 at 09:51 AM. |
Thread Tools | Search this Thread |
Display Modes | |
|
|