All MetalShaping

Go Back   All MetalShaping > Metal Shaping Projects > Automotive Projects
  Today's Posts Posts for Last 7 Days Posts for Last 14 Days  

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #6  
Old 10-08-2014, 06:52 PM
Gojeep's Avatar
Gojeep Gojeep is offline
MetalShaper of the Month March 2015, March 2020,, June 2022,Aug 2023
 
Join Date: Nov 2013
Location: Eastern Melbourne, Australia
Posts: 2,986
Default


Just making up the outer support for the rear shock absorbers. This gives them what is called double shear support as supported on both sides. The folds were done at a 8* angle so I would end up with a 8* slope to match that of the threaded boss that has already been welded into the frame.


Here you can see the result. The face that the bolt goes through is at 8*. This is to match what was on the Grand Cherokee as the lower shock mounts on the axle are wider than on the chassis. I also added an extra 16* in the legs. The top would have tilted downwards 8* other wise and I added another 8* so it actually tilted upwards for a better look.


The folds were simply hammered over in a 6" offset bench vise so I would get a softer fold. I clamped the centre section for both folds as wanted that to remain as flat as possible.


I added holes in the support top plate as well as the legs to take the heaviness out of the bracket.


All welded up. Was going to grind and sand them smooth, but thinking I might just leave it as is?


This how it will sit on the frame rail with the shock angle 8* outwards. Also will be angled similar to this to reach the axle which will be centred forward of the mount.


The bolt was only done up finger tight and had a piece of card placed in-between to allow for paint thickness.


As nothing will be welded directly on the other side of the mount, it would cause bending as the weld starts to cool. So I used half of the old bumper that was on the Willys and some 1/4" flat centred over the mount and clamped it down.


The pressure applied is in the reverse direction to which the welding will try to pull it. The weld will try to pull downwards and the clamps, with the flat underneath, is trying to bend it upwards.


The tricked worked quite well with one side remaining perfectly straight and the other just moving a fraction, which I pressed out straight.
__________________
Marcus
aka. Gojeep
Victoria, Australia
http://willyshotrod.com

Invention is a combination of brains and materials.
The more brains you use, the less materials you need.

Last edited by Gojeep; 08-01-2017 at 03:00 AM.
Reply With Quote
 

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump

All times are GMT -5. The time now is 12:05 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.