|
|
|
#1
10-02-2011, 06:30 PM
|
|||
|
|||
Circle shear I just picked up
Having wanted a set of radius gauge for to long , I figured it might in the long run be better to be able to make my own . I an thinking about stretching it a lot , it will flange also. Drove 13 hr round trip in a 96 F150 to pick it up. I am thinking if it will do 3/16 mild steel it would probably do 14" soft aluminum also I have not cut anything yet in that I have issues with variable drive unit,it is stuck on full blast , and the cuttters need attention. The company is still around it seems .
 Cuts 6" to 52" Circle Flanges 3/8" Maximum Gear Box 5 to 1 Ratio Head Throat 14" Length 78", Height 60", Width 40" Weight 1000 lbs. Rack and Pinion Gear Feed on Tail Stock for Easy Adjustment Capacity 3/16" Mild Steel, 10 Gauge Stainless Steel Motor 3/4 hp, 1750 RPM, AC 115 Volt Cutter Speed Variable from 0 to 350 RPM Tail Throat 38" Deep 
|
|
#3
10-03-2011, 04:51 AM
|
|||
|
|||
|
Nice macchine i have one just like it. Very useful sometimes
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
