#11
|
|||
|
|||
Careful with those gears! There are more than a few lathes around that are missing teeth on the back gear from the impact load of someone whacking a pry bar clamped in the chuck. If your chuck has a ring around the back with holes or slots for a spanner, it’s probably a "L" type mount. Post a picture if you can or look up pictures of lathe chuck mounts and we can go from there.
__________________
Bob Innes Last edited by Bad Bob; 12-15-2017 at 11:12 PM. Reason: CRS |
Thread Tools | Search this Thread |
Display Modes | |
|
|