|
|
|
#1
04-12-2020, 11:45 AM
|
|||
|
|||
New member from the Lone Star State
Doug from Fort Worth here! Guess it's appropriate to say howdy y'all!
My first car is a '56 Ragtop VW beetle that i purchased as a teen in '86 and still have. Been involved with sheet metal and basic metal fabrication for a bit throughout my career and hobbies. Several years ago I picked up a '69 Convertible Karmann Ghia that I have been converting to AWD. The geometry and driveline are established so it's on to body work. I have owned Subarus for many years so it only seemed natural to save a car from the crusher and give it a modern twist. Panels are hard to find in good shape, especially fenders. There are no reproduction fenders available for these cars. With the widened stance of the Ghia, I need to fabricate sheet metal for the car and why I am interested in joining this site. Looking forward to learning some techniques and fabricating some tools.
__________________
Doug My world is flat, as far as engines are concerned. 
|
|
#2
04-12-2020, 11:54 AM
|
||||
|
||||
|
Hi Doug
Your membership is approved Welcome to Allmetalshaping Steve
__________________
Steve Hamilton Hamilton Classics Auto Restoration & Metalshaping
|
|
#3
04-12-2020, 03:40 PM
|
|||
|
|||
|
Welcome to the forum, Doug.
__________________
AC Button II http://CarolinaSculptureStudio.com https://www.youtube.com/channel/UCzSYaYdis55gE-vqifzjA6A Carolina Sculpture Studio Channel
|
|
#4
04-13-2020, 07:08 AM
|
|||
|
|||
|
Welcome to the group doug
__________________
TOM KING I TYPE IN CAPS BECAUSE I AM LEGALLY BLIND
|
 |
|
|
Linear Mode
