#321
|
||||
|
||||
thank you charlie
__________________
Neil |
#322
|
|||
|
|||
Top work here, congrats!
Antoine
__________________
Antoine Puygranier Resurrecting a 60 ghia: http://www.allmetalshaping.com/showthread.php?t=18852 Fixing a 914: https://allmetalshaping.com/showthread.php?t=20624 |
#323
|
||||
|
||||
thank you Antoine, i am following your ghia build
__________________
Neil |
#324
|
||||
|
||||
so working around the wheel well closing panels, i made a paper template of the closing panel that goes between the hood opening flange and the petrol tank floor. i missed a few steps in the pictures, you've all seen a paper pattern lol.
i did make a steel template of a recess that this panel has, it's not exactly the same as porsche made it but it has the same effect. i made the steel template 2mm thick, not very deep but you see the pattern, it has a crease through recess so the panel can follow the mounting flange. i made a male and female pattern, lined them up on the panel, clamped the female and taped the male then ran it through the wheel to create the indentations. pity you can see where the spot welds have left marks after going through the wheel thanks for watching
__________________
Neil |
#325
|
|||
|
|||
Well done, nice panel
Antoine
__________________
Antoine Puygranier Resurrecting a 60 ghia: http://www.allmetalshaping.com/showthread.php?t=18852 Fixing a 914: https://allmetalshaping.com/showthread.php?t=20624 |
#326
|
|||
|
|||
I just went through the whole thread and loved it! well done, looking forward to more progress.
jurica
__________________
Jurica Kalcina |
Thread Tools | Search this Thread |
Display Modes | |
|
|