#1
|
|||
|
|||
A/V rack (pics fixed)
This is my first paid job in my new shop, I just started it yesterday and trying to document it as best as I can. I know it's not as elaborate as the things most of you do but it's a start and it's some money.
It will hold 4 A/V units 2 on each side suspended out from the frame and one speaker will go on a pedestal on top. This is the blank I cut out to get started it is 18 gauge A blank.jpg Setting up to put the radius in the top and bottom, I had to dismantle my grinder stand so I could use the pipe out of it for the longer bend A setting up to form radius.jpg A bending radius.jpg This is the rough shape A preliminary shape.jpg I used a guide for my Bad Dog nibbler to cut all the pieces, I am beginning to hate that thing, I see a plasma cutter in my near future A nibler guide.jpg This is it tack welded up A tack welded2.jpg A tack welded1.jpg More to come as I progress Last edited by Charley Davidson; 06-12-2010 at 04:52 PM. |
#2
|
||||
|
||||
Charley.
Glade you've settled in to the stage you can charge for jobs, good luck with your future plans. (couldn't see the pics but OK since I posted my reply) Cheers.
__________________
Tom Poulter Follow the Dream - Sideways - - But don't fall-off the edge 'good to know you guys care' https://ctrestorations.com/ Last edited by Z5Roadster; 06-12-2010 at 04:39 PM. Reason: ref pic problem |
#3
|
|||
|
|||
Fixed them
|
#4
|
|||
|
|||
Started the arm that holds one of the A/V units, there will be 2 on each side
This is the blank I started with Then each step I took as it progressed I built a stake dolly to bend the arm on nice and square using the flat end of my bowling pin hammer A.jpg B.jpg C.jpg D.jpg E.jpg F.jpg G.jpg H.jpg I.jpg Tipping Vice.jpg |
Thread Tools | Search this Thread |
Display Modes | |
|
|