#1
|
|||
|
|||
New to metal shaping
Hey Everyone,
I'm Mike from Highland, IL (about 30 miles east of St. Louis, MO). I'm here because I bought a 1969 AMC Javelin last year, and there aren't a lot of replacement panels for those cars. There are tons of things I need to learn how to do, including: - Make patch panels to replace rusted metal - Improve dent removal techniques (there are LOTS of dents!) - Fabricate inner wheel wells - Install replacement floor pans and quarter panels - Fabricate trans tunnel (for larger transmission) - Remove drip rails - Flush mount windows I also need to purchase several tools (on a budget), so I'm looking for advice there as well! Thanks, Mike
__________________
Mike D. |
#2
|
|||
|
|||
Hi Mike welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM |
Thread Tools | Search this Thread |
Display Modes | |
|
|