#1
|
|||
|
|||
Hello from UK
Hi All,
I'm Rob from Crewe in the UK. While I've always been mechanically minded I've recently started restoring my old MX5 (aka Miata) and I'm seeking some sheet metal fabrication tips Thanks Rob
__________________
Rob Evans |
#2
|
|||
|
|||
Welcome to the forum, Rob
Small world, I'm just down the road in Alsager! |
#3
|
|||
|
|||
We'll I didn't expect my first contact with someone to be from Alsager Thanks for the welcome
__________________
Rob Evans |
#4
|
|||
|
|||
Second welcome from Uttoxeter in Staffordshire
A bit further down the road from Dan, but not a lot. Plenty to see and learn here Rob.
__________________
Gareth Davies |
#5
|
||||
|
||||
Welcome Rob all the way from North Devon, some very knowledgeable people here only too willing to share.
Enjoy the site.
__________________
Tom Poulter Follow the Dream - Sideways - - But don't fall-off the edge 'good to know you guys care' https://ctrestorations.com/ |
#6
|
|||
|
|||
Hi Rob welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM |
#7
|
|||
|
|||
Hi Rob welcome to the forum, I'm a bit further south near Oxford, but I was up at Bentley's in Crewe a month ago, so know the area. Lots of good info and helpful folk here.
__________________
David Hamer |
|
|