|
|
|
|
|
#1
03-10-2012, 06:06 AM
|
|||
|
|||
The French Firebird
Hello everyone,
I thought this forum was missing some french people so here I am.  More seriously, I am living in the south west of France and I recently bought a 71 pontiac firebird which is in need of a ground up restoration. There is a lot to do regarding sheet metal. I posess the basic tools : hammers and dollies, shrinker/stretcher and a mig but I still miss some practice and advice regarding metal shaping. That's why I enroled... See you on the forums Julien
__________________
Julien 
|
|
#2
03-10-2012, 08:31 AM
|
|||
|
|||
|
Welcome to the site Julien
__________________
Bill Hartson Well done is better than well said. -Benjamin Franklin
|
|
#4
03-10-2012, 09:01 PM
|
|||
|
|||
|
HI Julien and welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Hybrid Mode
