Hi Group,
I have a newbie question on how to get the line back in this fender (first pic) that was done by someone else years ago. They even leaded in the work so they must have been knowledgeable as to what to do.
The car in question is a 1957 Morris Minor. Iv'e worked on the flat part a bit and the curve to the side but I'm not sure how to reestablish the line from the top of the fender to the bottom edge that passes by the headlight bucket mount.
Pic #2 is the other fender that is untouched and shows what I'm trying to accomplish.
Basic hand tools, a couple of welders, OA set, mill, lathe, and I can make a dolly or form to work with if I can get help as to what I need.
TX
Mr fixit
Chris
metal shaping post.jpg 1.jpg
metal shaping post.jpg.jpg